Click Images To Enlarge
F56 WEATHER-PROOF HEX-CRIMP CONNECTORS Packs of 10-25-50-100
Designed for RG6 Coaxial Cable. Compatible with all satellite TV systems: DirecTV, Dish Network, C-Band and Free-to-Air. Also compatible with all cable TV services. Precision Machine Brass Construction Zinc Plated ~ Corrosion Resistant. Rubber "O" Ring Insert and Silicone Gel flooded ~ Watertight and Weatherproof. Improved Conductivity. Designed to permanently "crimp-on". SOLD IN BAGS OF 100 CONNECTORS.
Quantity

NICKEL-PLATED F56 HEX-CRIMP CONNECTORS Packs of 10-25-50-100
Cable connectors are of non-corrosive nickel plated brass construction ~ Easy Crimp Extra-Long (1/2 inch) Barrel ~ For use with RG6 coaxial cable ~ Improved Conductivity ~ Designed to permanently "crimp-on".  Indoor use. 
Quantity

PPC EX6 (BAG of 50 pieces) Bag of 50: $19.99
For use with RG6 coaxial cable. All Brass Connector. Non-corrosive, will not rust. 360° Swedge Compression. Fully Sealed - Watertight - Without the Need for Silicone Grease. Sold in bags of 50 Pieces.
 

PPC EX6WS AUQA-TIGHT™ SERIES Bag of 50: $29.99
For use with RG6 coaxial cable. All Brass Connector. 360° Swedge Compression. For use in outdoor installations. The AquaTight® EX® Series is a revolutionary design concept that combines the EX® Series compression connector above with an integrated port seal. This innovative design guarantees the use of a port seal every time so that moisture migration problems are eliminated. The AquaTight® nut design also allows the installer to fully seat the connector on a port by hand. Seals on various port sizes eliminating errors from using an incorrect weather seal size. Sold in bags of 50 Pieces.

PPC EX11N716WS AUQA-TIGHT™ SERIES $3.49 Each
For use with RG11 coaxial cable. All Brass Connector. 360° Swedge Compression. Fully Sealed - Watertight - Without the Need for Silicone Grease. Seals on various port sizes eliminating errors from using an incorrect weather seal size. SOLD INDIVIDUALLY.
 

DIGICON RED F59 CONNECTORS: Packs of 10, 25, 50 and 100
For use with RG59 coaxial cable. All Brass Connector. 360° Swedge Compression. Fully Sealed - Watertight - Without the Need for Silicone Grease. SOLD IN BAGS OF 10 - 25 - 50 & 100 PIECES.
Quantity

DIGICON BLUE F56 CONNECTORS: Packs of 10, 25, 50 and 100
For use with standard RG6 coaxial cable. All Brass Connector. 360° Swedge Compression. Fully Sealed - Watertight - Without the Need for Silicone Grease. SOLD IN BAGS OF 10 - 25 - 50 & 100 PIECES.
Quantity

DIGICON GREEN F56 CONNECTORS: Packs of 10, 25, 50 and 100
For use with quad-shielded RG6 coaxial cable. All Brass Connector. 360° Swedge Compression. Fully Sealed - Watertight - Without the Need for Silicone Grease. SOLD IN BAGS OF 10 - 25 -50 & 100 PIECES.
Quantity

Universal RidgeLoc F56 Connectors - Bag of 50: $19.99
This universal connector fits any standard quad-shield, trishield or dual shield RG-6 75 Ohm coax cable.  The RIDGELOC 360 is suitable for indoor applications and is completely SCTE tested and weatherproof for hostile outdoor environments. Other features include a extremely rugged machined body, mil spec plating and dimpled grip.  Compression Tool 21 millimeters.  Stock Number PV6UE-05

Radial 360°Concentric Compression-Crimp Connectors - Bag of 100: $39.99
Concentric crimp style cable connector. Professional quality - polished brass - non-corrosive. Internal rubber o-ring. Maximum pull-out strength. Watertight seal. Eliminates signal radiation leakage.  Uses this type tool for compression bonding to coaxial jacket.

TWIST-ON F56 CONNECTORS - Bag of 10: $3.99
These durable "twist-on" connectors can be fitted to RG6 coaxial cable quickly and easily without the use of a crimp tool. Although not recommended for permanent installations, there's been many times I could have used a couple of these. Just peel back the cable and screw it on. PACKAGE OF 10 CONNECTORS. No crimp tool required. 

F to F / PUSH-ON QUICK F-CONNECTOR - Bag of 5: $1.99
When screwing and unscrewing presents a problem! Especially useful when you're testing equipment or for homeowners removing their satellite receivers to take along on camping trips. Screw it on ONE time! Then push or pull to connect or reconnect. PACKAGE OF 5 CONNECTORS. 

F CONNECTOR TO RCA PLUG - Bag of 5: $4.99
Make your own RCA Patch Cords! Having problems finding the right length RCA patch cord to connect your stereo equipment? These adaptors will solve that problem! Step one: Cut RG6 coaxial cable to proper length. Step two: Crimp F56 connectors on both ends of the coax. Step three: Attach one of these adaptors at both ends. THAT'S IT! Also quick solution if you have coax installed in the wall and need a video or audio link through the coax. PACKAGE OF 5 CONNECTORS. 

F CONNECTOR TO BNC PLUG ADAPTER - Bag of 2: $4.99
Make your own BNC CABLES! Having problems finding the right length BNC cable? These adaptors will solve that problem! Step one: Cut RG6 coaxial cable to proper length. Step two: Crimp F56 connectors on both ends of the coax. Step three: Attach one of these adaptors at both ends. THAT'S IT! Also quick solution if you have coax installed in the wall and need a video or audio link through the coax.  PACKAGE OF 2 CONNECTORS. 

Standard VHF/UHF F81 BARREL CONNECTORS - Bag of 10: $2.99
The components are designed for VHF/UHF frequencies (5 - 1000 MHz or 1 GHz).  Internally, the time-proven center conductor spring-contact design provides dependable and repeatable connections.  White suspension plastic insulators on both ends indicate low frequency design and avoid accidental use in a high frequency environment.  Used to connect (splice) coaxial cable RG6 and RG59.  Can easily be used in wall plates with the addition of a thin capture nut (optional/not included).  Minimal insertion loss.

Hi-Frquency F81 BARREL CONNECTORS: Packs of 10, 25, 50 and 100
3 GHz High Frequency F81 Barrel Splice Connectors.  The internal components are much different from a standard VHF/UHF barrel connector.  The center coax conductor indexes into a close-tollerance tube that is resilient (spring) brass and is gold plated.  Internally, the center conductor tube is insulated from the inner skin of the barrel by a maximum air gap which results in much less RF loss.  Insertion loss is a non-issue.
Quantity

Hi-Frquency F81 BARREL CONNECTORS - Pack of 50: $24.99
0 to 3 GHz High Frequency Barrel Splice Connector manufactured to same specifications as Hi-Frquency Barrel Connectors as above but these barrel connectors meet SCTE standards, are DirecTV approved, and come with washers and nuts.  Recommended for inside use only in wallplates or to splice cables.  For outside weatherproff barrel connectors, see panel below.  Gold-Plated hence the gold-colored insert.

Weatherproof Hi-Frquency F81 BARREL CONNECTORS - Bag of 10: $7.99
It is rated for 0 MHz to 3 GHz. This in-line spice connector is intended for outdoor use. Rubber weather seals on each side provide an added layer of moisture resistance. Meets SCTE standards - DIRECTV approved.  Gold-Plated hence the gold-colored insert.

Right Angle (90°) VHF/UHF  F ADAPTER - Bag of 4: $3.99
These 90° F Adaptors make multi-switch installs inside all-weather enclosures a snap. Also saves wear and tear on satellite meters and other electronic gadgets especially flat panel television sets hugging the wall.

Standard F TERMINATOR - Bag of 10:  $2.49
All open or unused ports on signal splitters, LNBF's, MultiSwitches, etc. should be terminated unless specified by manufacturer. By doing so, you are reducing the load on the device, decreasing signal leakage, increasing signal strength and protecting the port from water-damage and corrosion. 75 Ohm DC. 1000 MHz / 1 MHz.

High Frequency (3 GHz) F TERMINATOR - Bag of 10:  $4.99
All open or unused ports on signal splitters, LNBF's, MultiSwitches, etc. should be terminated unless specified by manufacturer. By doing so, you are reducing the load on the device, decreasing signal leakage, increasing signal strength and protecting the port from water-damage and corrosion. 75 Ohm DC. 3000 MHz / 3 GHz.

Right-Angle 180º Adjustable Male to Female HDMI Adapter $14.99 Each
HDMI jack to plug - Supports full HD video / audio transmission - Allows easier access to HDMI ports especially behind flat screen wall mounts - allows flat-panel televisions to be pushed back further toward the wall.  Full 180º adjustable.  Stock Number IM528-002

RCA to RCA BI-DIRECTIONAL IN-LINE COUPLER - Bag of 3: $2.99
These 24k gold-plated RCA Female to RCA Female Bi-Directional In-Line Couplers are ideal for splicing two existing RCA Cables and solving the "short-drop" dilemma. Less than $1 each!  Stock Number IM528-002

SVHS to SVHS (S-Video) BI-DIRECTIONAL IN-LINE COUPLER - $3.99 Each
These 24k gold-plated SVHS Female to SVHS Female Bi-Directional In-Line Couplers are ideal for splicing two existing SVHS (Super-Video) cables and solving the "short-drop" dilemma.  Stock Number: IM251-410

COMPONENT VIDEO BI-DIRECTIONAL IN-LINE COUPLER - $2.99 Each
These 24k gold-plated 3-RCA (RGB) Female to 3-RCA (RGB) Female Bi-Directional In-Line Couplers are ideal for splicing two existing Component Video Cables and solving the "short-drop" dilemma.  Stock Number IM251-117

DVI-D Male to HDMI Female Adapter - $19.99 Each
These premium quality adapters offer an effective digital video signal transmission path between HDMI and DVI-D (single link) compatible devices. They provide a reliable connectivity solution for DVD players, set-top terminals, flat-panel displays, plasma displays and HDTV sets. Constructed to HDMI v1.1 and DVI v1.0 specifications, each adapter features gold-plated beryllium copper contacts, a 100% coverage copper foil shield, a nickel-plated steel connector shell, and a fully molded PVC body and connector over-mold. Stock Number IM516-007

DVI-D Female to HDMI Male Adapter - $19.99 Each
These premium quality adapters offer an effective digital video signal transmission path between HDMI and DVI-D (single link) compatible devices. They provide a reliable connectivity solution for DVD players, set-top terminals, flat-panel displays, plasma displays and HDTV sets. Constructed to HDMI v1.1 and DVI v1.0 speci­fications, each adapter features gold-plated beryllium copper contacts, a 100% coverage copper foil shield, a nickel-plated steel connector shell, and a fully molded PVC body and connector over-mold.  Stock Number IM516-008

2 RCA JACKS TO 1 RCA PLUG - $2.99 Each
Audio/Video Adaptor converts ONE female port to TWO female ports (input or output). 24 Karat Gold-Plated Connectors for increased conductivity.  Stock Number IM251-113

HDMI Female to HDMI Female In-Line Coupler - $14.99 Each
Connects to HDMI cables up to maximum distance supported by source devices.  Couple 2 HDMII® cables for longer runs.  High-definition multimedia interface adapter.  Stock Number IM528-006.


RJ11 Modular Phone Plugs - Bag of 100 pieces: $7.99
Most commonly used for modular telephone connections. This is actually a 6P6C plug body with only the inner four crimp blades present converting it to an RJ-11 6P4C. This is a crimp connection. You must use a crimp tool designed for the 6P6C modular body such as the tool in the below panel. Typically the center two contacts are used for 'tip' and 'ring' with the outer two contacts utilized for other purposes like grounding or low voltage phone lighting.  Modular phone plug. Gold plated crimp blades. For solid AWG 24 wire. Clear body to allow view of wire color alignment. Two-pair connections 6P4C. Can also be used as a 6P2C device if only one pair is required.

RJ45  Ethernet Plugs (8P8C) for CAT 5 or CAT 5e Cable - Bag of 25: $8.99
Terminates 24 through 28-gauge solid or stranded CAT 5 or CAT 5e cable. Gold-plated blades for maximum conductivity (signal transfer). 8X8 (8P8C).  Use the Crimp Tool in the panel above to attach these connectors.

Cable Security Shields - $.79 each
Designed and manufactured orignally to prevent rogues from stealing cable TV service - these shields are now used extensively in the hospitality business to prevent rogues from stealing television sets from motel rooms.  These security shields can also be used to secure parental control units, DVD players, and satellite receivers. Click on the picture for details.  Click on the "Tools Page" for the insertion/removal tool for these shields.